Product Name:	Human EXT1 / Exostoses 1 ELISA Kit
Product Code:	HUFI02434
Size:	96 Assays
Alias:	EXT1, LGCR, TRPS2, TTV, EC 2.4.1.224, EC 2.4.1.225, exostoses, multiple 1, exostosin 1, exostosin-1, EXT, Glucuronosyl-N-acetylglucosaminyl-proteoglycan 4-alpha-N-acetylglucosaminyltransferase
Detection method:	Sandwich ELISA, Double Antibody
Application:	This immunoassay kit allows for the in vitro quantitative determination of Human EXT1 concentrations in serum plasma and other biological fluids.
Sensitivity:	0.469ng/ml
Range:	0.781-50ng/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Human EXT1 and the recovery rates were calculated by comparing the measured value to the expected amount of Human EXT1 in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	88-102	97
EDTA plasma(n=5)	85-101	93
UFH plasma(n=5)	87-95	90

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Human EXT1 and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	87-105%	86-105%	88-102%
EDTA plasma(n=5)	88-100%	82-95%	82-101%
UFH plasma(n=5)	84-99%	87-99%	80-97%

CV(%):

Intra-Assay: CV<8%
Inter-Assay: CV<10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

Q16394

UniProt Protein Function:	EXT1: Glycosyltransferase required for the biosynthesis of heparan-sulfate. The EXT1/EXT2 complex possesses substantially higher glycosyltransferase activity than EXT1 or EXT2 alone. Appears to be a tumor suppressor. Defects in EXT1 are a cause of hereditary multiple exostoses type 1 (EXT1). EXT is a genetically heterogeneous bone disorder caused by genes segregating on human chromosomes 8, 11, and 19 and designated EXT1, EXT2 and EXT3 respectively. EXT is a dominantly inherited skeletal disorder primarily affecting endochondral bone during growth. The disease is characterized by formation of numerous cartilage-capped, benign bone tumors (osteocartilaginous exostoses or osteochondromas) that are often accompanied by skeletal deformities and short stature. In a small percentage of cases exostoses have exhibited malignant transformation resulting in an osteosarcoma or chondrosarcoma. Osteochondromas development can also occur as a sporadic event. Defects in EXT1 are a cause of tricho-rhino-phalangeal syndrome type 2 (TRPS2). A syndrome that combines the clinical features of trichorhinophalangeal syndrome type 1 and multiple exostoses type 1. Affected individuals manifest multiple dysmorphic facial features including large, laterally protruding ears, a bulbous nose, an elongated upper lip, as well as sparse scalp hair, winged scapulae, multiple cartilaginous exostoses, redundant skin, and mental retardation. A chromosomal aberration resulting in the loss of functional copies of TRPS1 and EXT1 has been found in TRPS2 patients. Defects in EXT1 are a cause of chondrosarcoma (CHDSA). It is a malignant neoplasm derived from cartilage cells. Chondrosarcomas range from slow-growing non-metastasizing lesions to highly aggressive metastasizing sarcomas. Belongs to the glycosyltransferase 47 family.
UniProt Protein Details:	Protein type:Membrane protein, integral; Glycan Metabolism - heparan sulfate biosynthesis; Tumor suppressor; Motility/polarity/chemotaxis; EC 2.4.1.225; EC 2.4.1.224; Transferase Chromosomal Location of Human Ortholog: 8q24.11 Cellular Component: Golgi membrane; Golgi apparatus; endoplasmic reticulum membrane; endoplasmic reticulum; integral to membrane; integral to endoplasmic reticulum membrane Molecular Function:acetylglucosaminyltransferase activity; transferase activity, transferring glycosyl groups; protein homodimerization activity; glucuronosyl-N-acetylglucosaminyl-proteoglycan 4-alpha-N-acetylglucosaminyltransferase activity; protein heterodimerization activity; glucuronosyltransferase activity; metal ion binding; heparan sulfate N-acetylglucosaminyltransferase activity; N-acetylglucosaminyl-proteoglycan 4-beta-glucuronosyltransferase activity Biological Process: glycosaminoglycan biosynthetic process; axon guidance; ossification; cellular polysaccharide biosynthetic process; heparan sulfate proteoglycan biosynthetic process, polysaccharide chain biosynthetic process; glycosaminoglycan metabolic process; olfactory bulb development; carbohydrate metabolic process; heparan sulfate proteoglycan biosynthetic process; protein amino acid glycosylation; gastrulation; pathogenesis; mesoderm development; signal transduction; skeletal development; endoderm development Disease: Chondrosarcoma; Exostoses, Multiple, Type I
NCBI Summary:	This gene encodes an endoplasmic reticulum-resident type II transmembrane glycosyltransferase involved in the chain elongation step of heparan sulfate biosynthesis. Mutations in this gene cause the type I form of multiple exostoses. [provided by RefSeq, Jul 2008]
UniProt Code:	Q16394
NCBI GenInfo Identifier:	20141422
NCBI Gene ID:	2131
NCBI Accession:	Q16394.2
UniProt Related Accession:	Q16394
Molecular Weight:	~ 86kDa
NCBI Full Name:	Exostosin-1
NCBI Synonym Full Names:	exostosin glycosyltransferase 1
NCBI Official Symbol:	EXT1Â Â
NCBI Official Synonym Symbols:	EXT; LGS; TTV; LGCR; TRPS2Â Â
NCBI Protein Information:	exostosin-1
UniProt Protein Name:	Exostosin-1
UniProt Synonym Protein Names:	Glucuronosyl-N-acetylglucosaminyl-proteoglycan/N-acetylglucosaminyl-proteoglycan 4-alpha-N-acetylglucosaminyltransferase; Multiple exostoses protein 1; Putative tumor suppressor protein EXT1
Protein Family:	Extensin
UniProt Gene Name:	EXT1Â Â
UniProt Entry Name:	EXT1_HUMAN

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Before adding to wells, equilibrate the SABC working solution and TMB substrate for at least 30 min at 37°C. When diluting samples and reagents, they must be mixed completely and evenly. It is recommended to plot a standard curve for each test.

Step	Protocol
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 Âµl of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 Âµl of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Tissue homogenates	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.

Inflammasome Activation Pathways: A Comprehensive Overview

Illuminating the Multifaceted Role of Acetylation: Bridging Chemistry and Biology Introduction:

Understanding IgA Test: Importance, Procedure, and Interpretation

Human EXT1 / Exostoses 1 ELISA Kit

Description