Mouse Deiodinase, Iodothyronine, Type II (DIO2) ELISA Kit
The Mouse Deiodinase Iodothyronine Type II (DIO2) ELISA Kit from AssayGenie is a cutting-edge tool for the precise measurement of DIO2 levels in mouse samples, including serum, plasma, and cell culture supernatants. With unparalleled sensitivity and specificity, this kit delivers dependable and consistent results, making it an invaluable resource for a wide array of research endeavors.DIO2 is a key enzyme involved in the conversion of thyroid hormone, playing a critical role in the regulation of metabolism and energy balance.
Dysregulation of DIO2 has been linked to various metabolic disorders, making it a vital target for investigation and therapeutic interventions.By utilizing the Mouse DIO2 ELISA Kit, researchers can gain valuable insights into the role of this enzyme in health and disease, paving the way for the development of novel treatments and diagnostic tools. Trust AssayGenie for accurate and reliable measurements of DIO2 levels in mouse samples, advancing your research with confidence.
Product Name:
Mouse Deiodinase, Iodothyronine, Type II (DIO2) ELISA Kit
Product Code:
MODL00372
Size:
96 Assays
Target:
DIO2
Synonyms:
5DII, D2, SelY, TXDI2, Thyroxine Deiodinase,Type II, Type-II 5'-deiodinase
Detection Method:
Sandwich
Range:
0.781-50ng/mL
Shelf Life:
12 months
Note:
For research use only
Recovery:
Matrices listed below were spiked with certain level of recombinant the index and the recovery rates were calculated by comparing the measured value to the expected amount of the index in samples.
Matrix
Recovery range (%)
Average(%)
Serum (n=5)
80-102
91
EDTA plasma (n=5)
81-100
90
Heparin plasma (n=5)
80-89
84
Linearity:
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of the index and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Sample
1:2
1:4
1:8
1:16
Serum (n=5)
82-96%
83-98%
81-99%
93-101%
EDTA plasma (n=5)
88-101%
86-95%
90-102%
80-93%
Heparin plasma (n=5)
80-91%
82-90%
95-104%
79-95%
Intra-assay Precision:
Intra-Assay: CV <10%. 3 samples with low, middle and high level the index were tested 20 times on one plate, respectively.
Inter-assay Precision:
Inter-Assay: CV <12%. 3 samples with low, middle and high level the index were tested on 3 different plates, 8 replicates in each plate.
Stability:
The stability of ELISA kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage conditions. Note: To minimize unnecessary influences on the performance, operation procedures and lab conditions, especially room temperature, air humidity and incubator temperatures should be strictly regulated. It is also strongly suggested that the whole assay is performed by the same experimenter from the beginning to the end.
Step
Protocol
1.
Prepare all reagents, samples and standards
2.
Add 100µL standard or sample to each well. Incubate 2 hours at 37°C
3.
Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C
4.
Aspirate and wash 3 times
5.
Add 100µL prepared Detection Reagent B. Incubate 1 hour at 37°C
6.
Aspirate and wash 5 times
7.
Add 90µL Substrate Solution. Incubate 15-25 minutes at 37°C
8.
Add 50µL Stop Solution. Read at 450nm immediately.
