Description
Peroxidase (POD) Activity Assay Kit (Plant samples)
The Assay Genie Peroxidase (POD) Activity Assay Kit (Plant samples) measures POD activity in plant tissue homogenates by a colorimetric endpoint. POD catalyzes the decomposition of H2O2, and the resulting oxygen oxidizes pyrogallic acid to a yellow product that is read at 420 nm. Researchers use the kit to quantify POD activity in oxidative stress and plant enzyme studies, normalized to tissue protein content.
Peroxidase (POD) is an enzyme that catalyzes the decomposition of hydrogen peroxide (H2O2) into water and oxygen. This kit quantifies POD activity in plant tissue samples, reported as units per milligram of tissue protein. The product is categorized under the oxidative stress research area, which reflects the role of H2O2-decomposing enzymes in peroxide handling within cells. Because the measurement reflects catalytic activity rather than enzyme mass, results describe functional enzyme capacity in each sample.
Researchers measure POD activity in plant studies that examine stress responses and physiological change. Publications cited with this kit address cadmium accumulation in rice, sugar starvation-promoted leaf senescence in rice, salt tolerance in wheat, berry color loss in muscadine grapes, somatic embryogenesis in Pinus nigra, and resistance to Botrytis cinerea in hazelnut. Across these contexts, POD activity serves as a biochemical readout for oxidative status in plant tissue.
The assay is colorimetric. A sample is combined with buffer, chromogenic application solution, and substrate application solution, then incubated at 37°C for 30 min. Oxygen released by the POD reaction oxidizes pyrogallic acid to form a yellow product. The reaction is stopped with stop application solution, the mixture is centrifuged at 2300×g for 10 min, and the supernatant is transferred to a microplate. Absorbance is read at 420 nm on a microplate reader operating between 410 and 430 nm. A parallel control tube, in which double-distilled water replaces the substrate solution, is run for each sample so that the control OD can be subtracted.
Plant tissue homogenate is the supported sample type, and the kit is not intended for serum or plasma. Tissue is harvested at an initial recommendation of 20 mg per assay, washed in cold double-distilled water, and homogenized in PBS (0.01 M, pH 7.4) at 4°C. After centrifugation at 10000×g for 10 min, the supernatant is kept on ice for detection. Because results are normalized to tissue protein, protein concentration of the supernatant must be determined separately. The recommended dilution factor is 1 for several listed plant tissues at 10% homogenate.
Sensitivity is 0.01 U/mL, and the detection range is 0.01 to 100 U/mL. The product page reports an intra-assay CV of 3.2% and an inter-assay CV of 5%. Recovery averages 102%, with individual recoveries of 99% to 105%. Manual precision data show intra-assay CVs of 2.9% to 3.6%. The total assay time is 1 h.
| Product Name: | Peroxidase (POD) Activity Assay Kit (Plant samples) |
| SKU: | MAES0152 |
| Size: | 96 Assays |
| Synonyms: | POD |
| Sample Type: | Plant tissue |
| Detection Method: | Colorimetric |
| Instrument: | Microplate reader (410-430 nm) |
| Assay Time: | 1 h |
| Research Area: | Oxidative stress; enzymes |
| Sensitivity: | 0.01 U/mL |
| Detection Range: | 0.01-100 U/mL |
| Recovery Rate: | 102% |
| Intra-assay CV: | 3.2% |
| Inter-assay CV: | 5% |
- Colorimetric endpoint assay read at 420 nm on a microplate reader (410-430 nm)
- Detection range 0.01-100 U/mL with sensitivity of 0.01 U/mL
- Validated for plant tissue homogenates; not for serum or plasma
- Assay time of approximately 1 h at 37°C
- Recovery rate of 102% and intra-assay CV of 3.2%
- Results expressed as U/mg protein when normalized to sample protein concentration
Peroxidase catalyzes the decomposition of H2O2 to water and oxygen. The oxygen oxidizes pyrogallic acid to form a yellow product. POD activity is calculated from the change in absorbance at 420 nm, using a sample reaction tube and a control tube that receives water in place of substrate solution.
- Quantifying POD activity in plant tissue homogenates in oxidative stress studies
- Comparing POD activity across plant tissues, such as green pepper, chive leaf, Photinia leaf, Epipremnum aureum, and white radish tissue homogenates
- Normalizing POD activity to tissue protein content (U/mg prot) for enzyme activity profiling
- Assessing peroxidase activity in plant enzyme and redox studies
| Component | Quantity | Storage |
| Reagent 1: Buffer Solution | 60 mL (1 vial) | 2-8°C, 12 months |
| Reagent 2: Chromogenic Powder | 2 agent vials | 2-8°C, 12 months, protect from light |
| Reagent 3: Substrate Solution | 1 mL (1 vial) | 2-8°C, 12 months |
| Reagent 4: Stop Solution | 20 mL (1 vial) | 2-8°C, 12 months |
| Microplate | 96 wells | No requirement |
| Plate Sealer | 2 pieces | No requirement |
| Sample Layout Sheet | 1 piece | No requirement |
- Microplate reader capable of reading 410-430 nm (420 nm for analysis)
- Vortex mixer
- Centrifuge (capable of 10000 ×g and 2300 ×g)
- 37°C incubator
- Homogenizer (Dounce-type) and ice
- Double-distilled water
- PBS (0.01 mol/L, pH 7.4)
- Normal saline (0.9% NaCl), optional diluent
- 1.5 mL EP tubes and calibrated pipettes
- Protein assay reagents to determine supernatant protein concentration
Plant tissue
- Harvest the amount of tissue needed for each assay (initial recommendation 20 mg).
- Wash tissue in cold double-distilled water.
- Homogenize 20 mg tissue in 180 µL PBS (0.01 M, pH 7.4) with a dounce homogenizer at 4°C.
- Centrifuge at 10000×g for 10 min to remove insoluble material. Collect the supernatant and keep it on ice for detection. Do not take the precipitate when collecting the supernatant.
- Determine the protein concentration of the supernatant using a separate protein assay, as required for the calculation.
Dilution of plant tissue homogenate
- Recommended dilution factor is 1 for 10% green pepper, chive leaf, photinia leaf, Epipremnum aureum, mushroom, and white radish tissue homogenates.
- Diluent is PBS (0.01 M, pH 7.4).
- For other sample types, perform a pretest to confirm the dilution factor.
- If the OD value of a sample tube is more than 0.7, dilute the sample and test again.
Reagent preparation
- Chromogenic application solution: dilute one vial of Chromogenic Powder with 8.75 mL double-distilled water and mix well. Store at 2-8°C for up to 1 month, protected from light.
- Substrate application solution (110 µL per well): mix 4.4 µL Substrate Solution with 105.6 µL double-distilled water. Prepare immediately before use.
- Stop application solution (200 µL per well): mix 100 µL Stop Solution with 100 µL double-distilled water. Prepare immediately before use.
Sample preparation (tissue)
- Harvest the tissue needed for each assay (initial recommendation: 20 mg). Wash in cold double-distilled water.
- Homogenize 20 mg tissue in 180 µL PBS (0.01 mol/L, pH 7.4) with a Dounce homogenizer at 4°C.
- Centrifuge at 10000 ×g for 10 min to remove insoluble material. Collect the supernatant and keep on ice.
- Determine the protein concentration of the supernatant with a separate protein assay.
- Dilute samples as needed. Recommended dilution factor is 1 for green pepper, chive leaf, Photinia leaf, Epipremnum aureum, mushroom, and white radish tissue homogenates (10%). For other sample types, pretest to confirm the dilution factor.
POD activity (U/mgprot) = ΔA ÷ (12 × 1) × V1 ÷ V2 ÷ t ÷ (Cpr ÷ f) × 1000
- Definition: 1 unit is the enzyme amount that catalyzes 1 µg substrate per minute per 1 mg tissue protein at 37°C.
- ΔA = OD(sample) − OD(control), unitless.
- 12 = absorption coefficient; 1 = optical path length in cm (300 µL in the microplate well).
- V1 = total reaction volume, 800 µL (0.8 mL).
- V2 = sample volume added to the reaction, 20 µL (0.02 mL).
- t = reaction time, 30 min.
- Cpr = protein concentration of the sample, mg protein/mL.
- f = dilution factor of the sample before testing; use 1 for undiluted samples.
- 1000 = conversion from µg to mg.
- Example: ΔA 0.406 with Cpr 2.18 mgprot/mL gives 0.406 ÷ (12 × 1) × 0.8 ÷ 0.02 ÷ 30 ÷ (2.18 ÷ 1) × 1000 = 20.69 U/mgprot for 10% green pepper tissue homogenate.
What sample types can be tested with this kit?
The kit is intended for measuring POD activity in plant tissue samples and is not for serum or plasma. The manual recommends a pretest for any sample type not listed in the instructions.
How should samples and reagents be stored?
Kit components are stored at 2-8°C for 12 months, and the chromogenic powder and substrate solution should be protected from light. The diluted chromogenic application solution can be stored at 2-8°C for 1 month, protected from light. Substrate and stop application solutions should be prepared on the spot for each assay.
What should I do if my sample is outside the detection range or the OD is too high?
The detection range is 0.01 to 100 U/mL. If the OD value of a sample tube is more than 0.7, dilute the sample and test it again. If the concentration is not within the detection range, an extra dilution or concentration should be taken for the sample.
What are the key points for obtaining reliable results?
Control the reaction time strictly and protect the reaction from light to limit variation between wells. Do not take the precipitate when transferring the supernatant. Complete the OD measurement within 30 min.
What instrument settings are required?
Read absorbance at 420 nm on a microplate reader with a detection capability of 410 to 430 nm. Use the 420 nm OD values for the sample and control wells in the calculation.
How long does the assay take?
The total assay time is 1 h. The sample incubation step is 37°C for 30 min, followed by stop solution addition and centrifugation at 2300×g for 10 min.