Rat Alkaline Phosphatase, Liver/Bone/Kidney (ALPL) ELISA Kit
The Rat Alkaline Phosphatase (ALPL) ELISA Kit is a powerful tool for measuring levels of ALPL in rat samples including liver, bone, and kidney tissues. This kit offers exceptional sensitivity and accuracy, guaranteeing precise and consistent results that are perfect for a variety of research purposes.ALPL is an enzyme essential for bone mineralization and plays a vital role in liver and kidney function. Abnormal levels of ALPL have been linked to various diseases and conditions, making it a valuable biomarker for studying and developing treatments for these health issues.
With the Rat ALPL ELISA Kit, researchers can easily quantify ALPL levels in rat samples, helping to advance our understanding of bone health, liver function, and kidney diseases. Trust in this kit for reliable data that will enhance your research efforts.
Product Name:
Rat Alkaline Phosphatase, Liver/Bone/Kidney (ALPL) ELISA Kit
Matrices listed below were spiked with certain level of recombinant the index and the recovery rates were calculated by comparing the measured value to the expected amount of the index in samples.
Matrix
Recovery range (%)
Average(%)
Serum (n=5)
80-102
91
EDTA plasma (n=5)
81-100
90
Heparin plasma (n=5)
80-89
84
Linearity:
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of the index and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Sample
1:2
1:4
1:8
1:16
Serum (n=5)
82-96%
83-98%
81-99%
93-101%
EDTA plasma (n=5)
88-101%
86-95%
90-102%
80-93%
Heparin plasma (n=5)
80-91%
82-90%
95-104%
79-95%
Intra-assay Precision:
Intra-Assay: CV <10%. 3 samples with low, middle and high level the index were tested 20 times on one plate, respectively.
Inter-assay Precision:
Inter-Assay: CV <12%. 3 samples with low, middle and high level the index were tested on 3 different plates, 8 replicates in each plate.
Stability:
The stability of ELISA kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage conditions. Note: To minimize unnecessary influences on the performance, operation procedures and lab conditions, especially room temperature, air humidity and incubator temperatures should be strictly regulated. It is also strongly suggested that the whole assay is performed by the same experimenter from the beginning to the end.
Step
Protocol
1.
Prepare all reagents, samples and standards
2.
Add 100µL standard or sample to each well. Incubate 2 hours at 37°C
3.
Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C
4.
Aspirate and wash 3 times
5.
Add 100µL prepared Detection Reagent B. Incubate 1 hour at 37°C
6.
Aspirate and wash 5 times
7.
Add 90µL Substrate Solution. Incubate 15-25 minutes at 37°C
8.
Add 50µL Stop Solution. Read at 450nm immediately.
