Mouse beta-hexosaminidase A/Beta Hex A ELISA Kit (MOFI01198)

Product Name:	Mouse beta-hexosaminidase A/Beta Hex A ELISA Kit
Product Code:	MOFI01198
Size:	96 Assays
Alias:	beta-Hex A, HEXA, TSD, beta-hexosaminidase subunit alpha, Beta-N-acetylhexosaminidase subunit alpha, hexosaminidase A, alpha polypeptide, Hexosaminidase subunit A, N-acetyl-beta-glucosaminidase subunit alpha
Detection Method:	Sandwich ELISA
Application:	This immunoassay kit allows for the in vitro quantitative determination of Mouse beta-Hex A concentrations in serum plasma and other biological fluids.
Sensitivity:	0.188ng/ml
Range:	0.313-20ng/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Mouse beta-Hex A and the recovery rates were calculated by comparing the measured value to the expected amount of Mouse beta-Hex A in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	88-105	95
EDTA plasma(n=5)	93-104	100
UFH plasma(n=5)	85-102	97

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Mouse beta-Hex A and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	88-105%	86-97%	91-105%
EDTA plasma(n=5)	87-99%	88-94%	87-101%
UFH plasma(n=5)	83-100%	86-99%	80-100%

Intra Assay:

CV <8%

Inter Assay:

CV <10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

P29416

UniProt Protein Function:	HEXA: Responsible for the degradation of GM2 gangliosides, and a variety of other molecules containing terminal N-acetyl hexosamines, in the brain and other tissues. The form B is active against certain oligosaccharides. The form S has no measurable activity. Defects in HEXA are the cause of GM2-gangliosidosis type 1 (GM2G1); also known as Tay-Sachs disease. GM2- gangliosidosis is an autosomal recessive lysosomal storage disease marked by the accumulation of GM2 gangliosides in the neuronal cells. GM2G1 is characterized by GM2 gangliosides accumulation in the absence of HEXA activity, leading to neurodegeneration and, in the infantile form, death in early childhood. GM2G1 has an increased incidence among Ashkenazi Jews and French Canadians in eastern Quebec. It exists in several forms: infantile (most common and most severe), juvenile and adult (late onset). Belongs to the glycosyl hydrolase 20 family. Protein type: Carbohydrate Metabolism - amino sugar and nucleotide sugar; EC 3.2.1.52; Glycan Metabolism - glycosaminoglycan degradation; Glycan Metabolism - glycosphingolipid biosynthesis - ganglio series; Glycan Metabolism - glycosphingolipid biosynthesis - globo series; Glycan Metabolism - other glycan degradation; Hydrolase Chromosomal Location of Human Ortholog: 9 B\|9 32.02 cM Cellular Component: azurophil granule; lysosome; membrane Molecular Function: acetylglucosaminyltransferase activity; beta-N-acetylhexosaminidase activity; hydrolase activity; hydrolase activity, acting on glycosyl bonds; hydrolase activity, hydrolyzing O-glycosyl compounds; protein heterodimerization activity Biological Process: adult walking behavior; carbohydrate metabolic process; cell morphogenesis involved in neuron differentiation; ganglioside catabolic process; glycosaminoglycan biosynthetic process; glycosaminoglycan metabolic process; lipid storage; locomotory behavior; lysosome organization and biogenesis; metabolic process; myelination; neuromuscular process controlling balance; neuromuscular process controlling posture; sensory perception of sound; sexual reproduction; skeletal system development
UniProt Protein Details:
NCBI Summary:	This gene encodes a member of the glycosyl hydrolase 20 family of proteins. The encoded preproprotein is proteolytically processed to generate the alpha subunit of the lysosomal enzyme beta-hexosaminidase. This enzyme, together with the cofactor GM2 activator protein, catalyzes the degradation of the ganglioside GM2, and other molecules containing terminal N-acetyl hexosamines. Mice lacking the encoded protein exhibit accumulation of gangliosides in the brain and membranous cytoplasmic bodies in neurons. Certain mutations in the human ortholog of this gene cause Tay-Sachs disease. [provided by RefSeq, Aug 2016]
UniProt Code:	P29416
NCBI GenInfo Identifier:	67514549
NCBI Gene ID:	15211
NCBI Accession:	NP_034551.2
UniProt Secondary Accession:	P29416,Q64246, Q91XG3
UniProt Related Accession:	P29416
Molecular Weight:	Predicted Molecular Mass: 28.2kDaAccurate Molecular Mass: 28kDa as determined by SDS-PAGE reducing conditions.
NCBI Full Name:	beta-hexosaminidase subunit alpha preproprotein
NCBI Synonym Full Names:	hexosaminidase A
NCBI Official Symbol:	Hexa
NCBI Official Synonym Symbols:	Hex-1
NCBI Protein Information:	beta-hexosaminidase subunit alpha
UniProt Protein Name:	Beta-hexosaminidase subunit alpha
UniProt Synonym Protein Names:	Beta-N-acetylhexosaminidase subunit alpha; Hexosaminidase subunit A; N-acetyl-beta-glucosaminidase subunit alpha
Protein Family:	Hexamerin
UniProt Gene Name:	Hexa
UniProt Entry Name:

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Step	Procedure
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample (Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µL of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µL of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum:	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma:	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid:	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant:	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates:	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20°C.
Tissue homogenates:	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates:	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk:	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.