Mouse IRE1/ERN1 ELISA Kit (MOFI00793)

Product Name:	Mouse IRE1/ERN1 ELISA Kit
Product Code:	MOFI00793
Size:	96 Assays
Alias:	ERN1
Detection Method:	Sandwich ELISA
Application:	This immunoassay kit allows for the in vitro quantitative determination of Mouse ERN1 concentrations in serum plasma and other biological fluids.
Sensitivity:	23.438pg/ml
Range:	39.063-2500pg/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Mouse ERN1 and the recovery rates were calculated by comparing the measured value to the expected amount of Mouse ERN1 in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	88-105	95
EDTA plasma(n=5)	86-104	95
UFH plasma(n=5)	89-100	97

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Mouse ERN1 and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	89-99%	93-102%	96-105%
EDTA plasma(n=5)	84-94%	83-99%	84-98%
UFH plasma(n=5)	80-100%	83-100%	81-97%

Intra Assay:

CV <8%

Inter Assay:

CV <10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

Q9EQY0

UniProt Protein Function:	IRE1: a ser/thr protein kinase that possess endonuclease activity. Important in altering gene expression as a response to endoplasmic reticulum based stress signals. Senses unfolded proteins in the lumen of the endoplasmic reticulum via its N-terminal domain, which leads to enzyme auto-activation. The active endoribonuclease domain splices XBP1 mRNA to generate a new C-terminus, converting it into a potent unfolded-protein response transcriptional activator and triggering growth arrest and apoptosis. The kinase domain is activated by trans-autophosphorylation. Kinase activity is required for activation of the endoribonuclease domain. Ubiquitously expressed. High levels observed in pancreatic tissue. Functionally connected with insulin biosynthesis in pancreatic beta cells. Homodimer; disulfide-linked. Dimer formation is driven by hydrophobic interactions within the N-terminal luminal domains and stabilized by disulfide bridges. Also binds HSPA5, a negative regulator of the unfolded protein response. This interaction may disrupt homodimerization and prevent activation of IRE1.
UniProt Protein Details:	Protein type:Kinase, protein; Chaperone; Membrane protein, integral; Apoptosis; EC 2.7.11.1; Endoplasmic reticulum; Ribonuclease; Protein kinase, Ser/Thr (non-receptor); Protein kinase, Other; Other group; IRE family Cellular Component: cytoplasm; endoplasmic reticulum; endoplasmic reticulum membrane; integral to endoplasmic reticulum membrane; mitochondrion; nuclear inner membrane Molecular Function:ADP binding; ATP binding; endonuclease activity; endoribonuclease activity; enzyme binding; Hsp70 protein binding; Hsp90 protein binding; identical protein binding; magnesium ion binding; protein binding; protein homodimerization activity; protein serine/threonine kinase activity Biological Process: activation of JNK activity; cell cycle arrest; endothelial cell proliferation; mRNA cleavage; positive regulation of RNA splicing; protein amino acid autophosphorylation; protein amino acid phosphorylation; unfolded protein response; unfolded protein response, activation of signaling protein activity
UniProt Code:	Q9EQY0
NCBI GenInfo Identifier:	51316086
NCBI Gene ID:	78943
NCBI Accession:	Q9EQY0.1
UniProt Secondary Accession:	Q9EQY0,Q9D340,
UniProt Related Accession:	Q9EQY0
Molecular Weight:	45,303 Da
NCBI Full Name:	Serine/threonine-protein kinase/endoribonuclease IRE1
NCBI Synonym Full Names:	endoplasmic reticulum (ER) to nucleus signalling 1
NCBI Official Symbol:	Ern1
NCBI Official Synonym Symbols:	Ire1a; Ire1p; C85377; AI225830; Ire1alpha; 9030414B18Rik
NCBI Protein Information:	serine/threonine-protein kinase/endoribonuclease IRE1
UniProt Protein Name:	Serine/threonine-protein kinase/endoribonuclease IRE1
UniProt Synonym Protein Names:	Endoplasmic reticulum-to-nucleus signaling 1; Inositol-requiring protein 1; Ire1-alpha; IRE1a
UniProt Gene Name:	Ern1
UniProt Entry Name:	ERN1_MOUSE

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Step	Procedure
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample (Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µL of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µL of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum:	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma:	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid:	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant:	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates:	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20°C.
Tissue homogenates:	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates:	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk:	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.