Mouse SLC17A5 (Sialin) ELISA Kit (MOFI00315)

Product Name:	Mouse SLC17A5 (Sialin) ELISA Kit
Product Code:	MOFI00315
Size:	96 Assays
Alias:	Slc17a5, Sialin, AST, ISSD, NSD, SIASD, SLC17A5, SLD, ASTSodium, sialic acid cotransporter, FLJ22227, FLJ23268, ISSD, Membrane glycoprotein HP59, NSD, SD, sialic acid storage disease, SIALIN, sialin, SIASD, SLDSolute carrier family 17 member 5, solute carrier family 17, anion, sugar transporter, member 5, solute carrier family 17, member 5
Detection Method:	Sandwich ELISA
Application:	This immunoassay kit allows for the in vitro quantitative determination of Mouse Slc17a5 concentrations in serum plasma and other biological fluids.
Sensitivity:	0.094ng/ml
Range:	0.156-10ng/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Mouse Slc17a5 and the recovery rates were calculated by comparing the measured value to the expected amount of Mouse Slc17a5 in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	91-105	98
EDTA plasma(n=5)	88-105	95
UFH plasma(n=5)	88-105	95

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Mouse Slc17a5 and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	86-103%	87-102%	94-104%
EDTA plasma(n=5)	86-99%	85-101%	90-98%
UFH plasma(n=5)	81-98%	87-99%	80-88%

Intra Assay:

CV <8%

Inter Assay:

CV <10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8-12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

Q8BN82

UniProt Protein Function:	SLC17A5: Primary solute translocator for anionic substances; particularly it is a free sialic acid transporter in the lysosomes (Probable). Defects in SLC17A5 are the cause of Salla disease (SD); also known as Finnish type sialuria. SD is a sialic acid storage disease (SASD). SASDs are autosomal recessive neurodegenerative disorders characterized by hypotonia, cerebellar ataxia and mental retardation. They are caused by a defect in the metabolism of sialic acid which results in increased urinary excretion of unconjugated sialic acid, specifically N- acetylneuraminic acid. Enlarged lysosomes are seen on electron microscopic studies. Clinical symptoms of SD present usually at age less than 1 year and progression is slow. Defects in SLC17A5 are the cause of infantile sialic acid storage disorder (ISSD); also known as N- acetylneuraminic acid storage disease (NSD). ISSD is a severe form of sialic acid storage disease. Affected newborns exhibit visceromegaly, coarse features and failure to thrive immediately after birth. These patients have a shortened life span, usually less than 2 years. Infantile sialic acid storage disorder is associated with non-immune hydrops fetalis, a generalized edema of the fetus with fluid accumulation in the body cavities due to non-immune causes. Non-immune hydrops fetalis is not a diagnosis in itself but a symptom, a feature of many genetic disorders, and the end- stage of a wide variety of disorders. Belongs to the major facilitator superfamily. Sodium/anion cotransporter family. 2 isoforms of the human protein are produced by alternative splicing.
UniProt Protein Details:	Protein type:Membrane protein, multi-pass; Transporter, SLC family; Transporter; Vesicle; Membrane protein, integral Cellular Component: membrane; lysosomal membrane; lysosome; cytoplasmic membrane-bound vesicle; cytoplasm; integral to membrane; plasma membrane; synapse; cytoplasmic vesicle; cell junction Molecular Function:symporter activity; sialic acid transmembrane transporter activity Biological Process: sialic acid transport; amino acid transport; transport; transmembrane transport
UniProt Code:	Q8BN82
NCBI GenInfo Identifier:	451172071
NCBI Gene ID:	235504
NCBI Accession:	NP_001263381.1
UniProt Secondary Accession:	Q8BN82,Q3TE25,
UniProt Related Accession:	Q8BN82
Molecular Weight:	25,879 Da
NCBI Full Name:	sialin isoform b
NCBI Synonym Full Names:	solute carrier family 17 (anion/sugar transporter), member 5
NCBI Official Symbol:	Slc17a5
NCBI Official Synonym Symbols:	SD; AST; NSD; SLD; ISSD; SIASD; SIALIN; 4732491M05; 4631416G20Rik
NCBI Protein Information:	sialin
UniProt Protein Name:	Sialin
UniProt Synonym Protein Names:	H(+)/nitrate cotransporter; H(+)/sialic acid cotransporter; AST; Solute carrier family 17 member 5; Vesicular H(+)/Aspartate-glutamate cotransporter
Protein Family:	Sialin
UniProt Gene Name:	Slc17a5
UniProt Entry Name:	S17A5_MOUSE

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Step	Procedure
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample (Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µL of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µL of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum:	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma:	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 - g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid:	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant:	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates:	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20°C.
Tissue homogenates:	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates:	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk:	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.

Mouse SLC17A5 (Sialin) ELISA Kit (MOFI00315)

Description