Rat Alpha-2-HS-glycoprotein/Ahsg ELISA Kit (RTFI00145)

Product Name:	Rat Alpha-2-HS-glycoprotein/Ahsg ELISA Kit
Product Code:	RTFI00145
Size:	96 Assays
Target:	Rat Ahsg
Alias:	Ahsg, AHSG, alpha-2-HS-glycoprotein, A2HS, AHS, alpha-2-HS-glycoprotein, alpha-2-Z-globulin, Alpha-2-Z-globulin, Ba-alpha-2-glycoprotein, FETUAba-alpha-2-glycoprotein, fetuin-A, Fetuin A, HSGA
Reactivity:	Rat
Detection Method:	Sandwich ELISA, Double Antibody
Sensitivity:	46.875pg/ml
Range:	78.125-5000pg/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Rat Ahsg and the recovery rates were calculated by comparing the measured value to the expected amount of Rat Ahsg in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	85-98	91
EDTA plasma(n=5)	90-101	95
UFH plasma(n=5)	95-104	100

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Rat Ahsg and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	92-105%	93-103%	88-102%
EDTA plasma(n=5)	86-101%	85-101%	87-98%
UFH plasma(n=5)	88-98%	83-92%	82-99%

Intra-Assay:

CV <8%

Inter-Assay:

CV <10%

Uniprot:

P24090

UniProt Protein Function:	FETUA: Promotes endocytosis, possesses opsonic properties and influences the mineral phase of bone. Shows affinity for calcium and barium ions. Alpha-2-HS glycoprotein derives from this precursor, when the connecting peptide is cleaved off. The two chains A and B are held together by a single disulfide bond. Synthesized in liver and selectively concentrated in bone matrix. Secreted in plasma. It is also found in dentin in much higher quantities than other plasma proteins. Belongs to the fetuin family.
UniProt Protein Details:	Protein type:Secreted, signal peptide; Secreted Cellular Component: extracellular matrix; extracellular space; protein complex Molecular Function:receptor signaling protein tyrosine kinase inhibitor activity; kinase inhibitor activity; cysteine protease inhibitor activity Biological Process: organ regeneration; ossification; male gonad development; negative regulation of insulin receptor signaling pathway; negative regulation of bone mineralization; cellular response to insulin stimulus; positive regulation of phagocytosis; regulation of inflammatory response; acute-phase response; positive regulation of bone resorption; negative regulation of phosphorylation; protein complex assembly; cerebral cortex development; negative regulation of cell growth
NCBI Summary:	inhibits insulin receptor tyrosine kinase activity; may be involved in bone mineralization and immune response [RGD, Feb 2006]
UniProt Code:	P24090
NCBI GenInfo Identifier:	6978477
NCBI Gene ID:	25373
NCBI Accession:	NP_037030.1
UniProt Secondary Accession:	P24090,Q5BKD2,
UniProt Related Accession:	P24090
Molecular Weight:	27.3kDa
NCBI Full Name:	alpha-2-HS-glycoprotein
NCBI Synonym Full Names:	alpha-2-HS-glycoprotein
NCBI Official Symbol:	Ahsg
NCBI Official Synonym Symbols:	pp63; Aa2-066
NCBI Protein Information:	alpha-2-HS-glycoprotein; BSP; fetuin-A; glycoprotein PP63; phosphorylated N-glycoprotein pp63; alpha 2 HS-glycoprotein alpha 2 (fetuin); 59 kDa bone sialic acid-containing protein
UniProt Protein Name:	Alpha-2-HS-glycoprotein
UniProt Synonym Protein Names:	59 kDa bone sialic acid-containing protein; BSP; Fetuin-A; Glycoprotein PP63
Protein Family:	Alpha-2-HS-glycoprotein
UniProt Gene Name:	Ahsg
UniProt Entry Name:	FETUA_RAT

Step	Procedure
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37°C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µL of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µL of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum:	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clotovernight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Removeserum and assay promptly or aliquot and store the samples at-80°C. Avoid multiple freeze-thaw cycles.
Plasma:	Collect plasma using EDTA or heparin as an anti-coagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid:	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell Culture Supernatant:	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell Lysates:	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20°C.
Tissue Homogenates:	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenizein 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or-80°C.
Tissue Lysates:	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk:	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.