Mouse EPOR (Erythropoietin receptor) ELISA Kit
This ELISA kit uses Sandwich-ELISA as the method. The micro ELISA plate provided in this kit has been pre-coated with an antibody specific to Mouse EPOR . Standards or samples are added to the appropriate micro ELISA plate wells and combined with the specific antibody. Then a biotinylated detection antibody specific for Mouse EPOR and Avidin-Horseradish Peroxidase (HRP) conjugate are added to each micro plate well successively and incubated. Free components are washed away. The substrate solution is added to each well. Only those wells that contain Mouse EPOR, biotinylated detection antibody and Avidin-HRP conjugate will appear blue in color. The enzyme-substrate reaction is terminated by adding Stop Solution and the color turns yellow. The optical density (OD) is measured spectrophotometrically at a wavelength of 450 nm ± 2 nm. The OD value is proportional to the concentration of Mouse EPOR. The concentration of Mouse EPOR in samples can be calculated by comparing the OD of the samples to the standard curve.
|Detection Range||0.31-20 ng/mL|
|Sample Volume Required Per Well||100uL|
|Sample Type||Serum, plasma and other biological fluids|
This kit recognizes Mouse EPOR in samples. No significant cross-reactivity or interference between Mouse EPOR and analogues was observed.
As the OD values of the standard curve may vary according to the conditions of the actual assay performance (e.g. operator, pipetting technique, washing technique or temperature effects), the operator should establish a standard curve for each test. Typical standard curve and data is provided below for reference only.
Intra-assay Precision (Precision within an assay): 3 samples with low, mid range and high level Mouse EPOR were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, mid range and high level Mouse EPOR were tested on 3 different plates, 20 replicates in each plate.
|Intra-assay Precision||Inter-assay Precision|
|C V (%)||6.00||4.43||3.42||5.71||4.21||4.37|
The recovery of Mouse EPOR spiked at three different levels in samples throughout the range of the assay was evaluated in various matrices.
|Sample Type||Range (%)||Average Recovery (%)|
|EDTA plasma (n=5)||92-107||100|
|Cell culture media (n=5)||93-107||100|
Samples were spiked with high concentrations of Mouse EPOR and diluted with Reference Standard & Sample Diluent to produce samples with values within the range of the assay.
|Serum (n=5)||EDTA plasma (n=5)||Cell culture media (n=5)|
Kit Components & Storage
An unopened kit can be stored at 4'C for 1 month. If the kit is not used within 1 month, store the items separately according to the following conditions once the kit is received.
|Micro ELISA Plate(Dismountable)||8 wells X12 strips||-20'C, 6 months|
|Reference Standard||2 vials|
|Concentrated Biotinylated Detection Ab (100X)||1 vial, 120 uL|
|Concentrated HRP Conjugate (100X)||1 vial, 120 uL||-20'C(shading light), 6 months|
|Reference Standard & Sample Diluent||1 vial, 20 mL||4'C, 6 months|
|Biotinylated Detection Ab Diluent||1 vial, 14 mL|
|HRP Conjugate Diluent||1 vial, 14 mL|
|Concentrated Wash Buffer (25X)||1 vial, 30 mL|
|Substrate Reagent||1 vial, 10 mL||4'C(shading light)|
|Stop Solution||1 vial, 10 mL||4'C|
|Plate Sealer||5 pieces|
|Product Description||1 copy|
|Certificate of Analysis||1 copy|
Mouse EPOR (Erythropoietin receptor) ELISA Kit (MOES00998) Assay procedure
- 1. Set standard, test sample and control (zero) wells on the pre-coated plate and record theirpositions. It is recommended to measure each standard and sample in duplicate. Note: addall solutions to the bottom of the plate wells while avoiding contact with the well walls. Ensuresolutions do not foam when adding to the wells.
- 2. Aliquot 100µl of standard solutions into the standard wells.
- 3. Add 100µl of Sample / Standard dilution buffer into the control (zero) well.
- 4. Add 100µl of properly diluted sample (serum, plasma, tissue homogenates and otherbiological fluids) into test sample wells.
- 5. Cover the plate with the sealer provided in the kit and incubate for 90 min at 37°C.
- 6. Aspirate the liquid from each well, do not wash. Immediately add 100µL of BiotinylatedDetection Ab working solution to each well. Cover the plate with a plate seal and gently mix.Incubate for 1 hour at 37°C.
- 7. Aspirate or decant the solution from the plate and add 350µL of wash buffer to each welland incubate for 1-2 minutes at room temperature. Aspirate the solution from each well andclap the plate on absorbent filter paper to dry. Repeat this process 3 times. Note: a microplatewasher can be used in this step and other wash steps.
- 8. Add 100µL of HRP Conjugate working solution to each well. Cover with a plate seal andincubate for 30 min at 37°C.
- 9. Aspirate or decant the solution from each well. Repeat the wash process for five times asconducted in step 7.
- 10. Add 90µL of Substrate Reagent to each well. Cover with a new plate seal and incubate forapproximately 15 min at 37°C. Protect the plate from light. Note: the reaction time can beshortened or extended according to the actual color change, but not by more than 30min.
- 11. Add 50 µL of Stop Solution to each well. Note: Adding the stop solution should be done inthe same order as the substrate solution.
- 12. Determine the optical density (OD value) of each well immediately with a microplate readerset at 450 nm.
Mouse EPOR (Erythropoietin receptor) ELISA Kit (MOES00998) Protein Information
|UniProt Protein Function:||EPOR: erythropoietin receptor: a member of the cytokine receptor family. Mediates erythropoietin-induced erythroblast proliferation, differentiation and survival. Upon EPO stimulation, EPOR dimerizes triggering the JAK2/STAT5 signaling cascade. In some cell types, can also activate STAT1 and STAT3. Forms homodimers on EPO stimulation. Tyrosine-phosphorylated EpoR may bind several SH2 domain-containing proteins including LYN, the adapter protein APS, SHP-1, SHP-2, JAK2, PI3 kinases, STAT5A/B, SOCS3, and CRKL. Defects in the erythropoietin receptor may produce erythroleukemia and familial erythrocytosis. Three alternatively-spliced isoforms have been described. Isoform EPOR-T, missing the cytoplasmic tail, acts as a dominant-negative receptor of EPOR-mediated signaling.|
|UniProt Protein Details:|
Protein type:Membrane protein, integral; Receptor, cytokine
Chromosomal Location of Human Ortholog: 9 A3|9 7.93 cM
Cellular Component: cytoplasm; external side of plasma membrane; extracellular region; integral component of membrane; membrane; plasma membrane
Molecular Function:erythropoietin receptor activity; hematopoietin/interferon-class (D200-domain) cytokine receptor activity; identical protein binding; protein binding; transmembrane receptor activity
Biological Process: brain development; cardiac muscle morphogensis; decidualization; elevation of cytosolic calcium ion concentration; embryonic development; heart development; heart morphogenesis; negative regulation of neuron apoptosis; negative regulation of nitric oxide biosynthetic process; positive regulation of cell proliferation; positive regulation of ERK1 and ERK2 cascade; positive regulation of neuron projection development; signal transduction; ventricular cardiac muscle tissue morphogenesis; viral process
|NCBI GenInfo Identifier:||116292186|
|NCBI Gene ID:||13857|
|UniProt Secondary Accession:||P14753,Q63852,|
|UniProt Related Accession:||P14753|
|NCBI Full Name:||erythropoietin receptor|
|NCBI Synonym Full Names:||erythropoietin receptor|
|NCBI Official Symbol:||Epor|
|NCBI Protein Information:||erythropoietin receptor|
|UniProt Protein Name:||Erythropoietin receptor|
|Protein Family:||Erythropoietin receptor|
|UniProt Gene Name:||Epor|